Cequent Towing Products 75448 Instrucciones De Instalación

Spare Tire
Hitch Shown In Proper Position
Equipment Required: Utility Knife
Fastener Kit: 75448F
Wrenches: 19 mm, Torque Wrench
Drill Bits: N/A
License Plate Mounting Location
8"
Figure 1.
1
Qty. (4) Hex Bolt, M12 x 1.25 x 35mm CL8.8
2
Qty. (4) Conical Toothed Washer ½
1. Notify vehicle owner that the fascia requires minor trimming to fit hitch.
2. Using a felt tipped pen, measure and mark an outline on the fascia described in Figure 1.
3. Using a utility knife, carefully cut out the fascia on the bottom inside section of the license plate mounting area as shown.
4. Raise hitch into position, aligning the holes in hitch with the two rearmost weldnuts in the bottom of frame rail, both sides.
5. Loosely install the M12 hex bolts and conical toothed washers, four places. Center hitch on fasteners.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2005, 2008 Cequent Towing Products
Installation Instructions
Suzuki Grand Vitara
Fascia
1-1/4"
Fascia
1-1/4"
Area to Trim
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft.
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3, SUV4
Existing Weldnuts - Typ.
Frame Rail
Sheet 1 of 3 75448N
Part Numbers:
75448
44543
87007
Max Gross Max Tongue
Trailer WT (LB)
4000
3500
Figure 2.
1
2
6-10-08
Form: F205 Rev A 5-6-05
WT (LB)
400
350
Rev. B