Environmental Protection - Ryobi CCC-1801M Manual De Utilización

EN
FR DE ES IT
Note: Scrubbing and polishing pads are not perforated
and cannot be rotated.
MAINTENANCE
WARNING
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation or
when blowing dust. If operation is dusty, also
wear a dust mask.
WARNING
To avoid serious personal injury, always remove
thebattery pack from the tool when cleaning or
performing any maintenance.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken ordestroy plastic which may
result in serious personal injury.
Only the parts listed in this manual are intended to be
repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.
CLEANING THE SCRUBBING PADS
To ensure longer life and optimum performance,
periodically clean all sanding residue and foreign
materials from the scrubbing and polishing pads.
This can be done simply by rinsing the pad with warm
water until all foreign material has been washed away.
After cleaning, gently squeeze the pad to remove excess
water and allow pad to dry. Always store pads and
sanding sheets flat in a cool dry location.
CLEANING THE SANDING SHEETS
The sanding sheets that came with the sander are made
to be re-used. Therefore, it is important that they be
cleaned periodically to remove sanding residue and
foreign material that can accumulate over time. To clean
sanding sheets, rub the sheets with a hard rubber block.
You can also use the clean rubber sole of a shoe.
WARNING
Always remove the scrubbing pad or sanding
sheet from the sander before cleaning. Failure to
NL PT DA SV FI NO
English
RU PL CS HU RO LV
do so could cause serious personal injury.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing as
waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
SYMBOL
Safety Alert
V Volts
min -1 Revolutions or reciprocations per minute
Direct current
CE Conformity
EurAsian Conformity Mark.
Wear ear protection
Wear eye protection
Please read the instructions carefully before
starting the machine.
Recycle unwanted
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
3
LT ET HR SL SK EL TR