PRESIDIUM ADAMAS Guía De Usuario página 7

5. Use the calibration pin provided
screw driver) to press and release the
Calibration Activation Button (Figure
5). The tester will enter calibration
mode with a beep sound. All
Indicator Lights (excluding Metal and
Low Batt) will light up in running lights
mode. The tester is now ready to start
calibration.
*Note : Ensure that the probe tip is
not resting against any object before
pressing the Calibration Activation
Button.
6. To begin calibrating, carefully press
the probe tip onto the Calibration Disk
perpendicularly as shown in Figure 6.
Ensure that the probe tip remains fully
depressed during this process, to
achieve consistent pressure on the
tip.
7
Figure 5
Figure 6