Wiring; Canopy Assembly - Craftmade Nikia Guia De Instalacion

7. Wiring.

WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
When downrod is secured in place on the hanging
bracket, electrical wiring can be
made as follows:
Connect BLACK and BLUE wire from fan to
BLACK wire from ceiling with wire connector
provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided. Connect all
GROUND (GREEN) wires together from fan to
BARE/GREEN wire from ceiling with wire
connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from fan
to the BLACK (or RED) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.

8. Canopy Assembly.

Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket
align with slotted holes in canopy, and then lower
canopy and partially loosen these 2 screws.
Remove the other 2 screws/lock washers and set
aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist
canopy to lock. Re-insert the other 2
screws/washers and secure all screws with a
Phillips screwdriver.
white supply wire
black supply wire
from ceiling
black
white
white
black
blue
from fan
This fan is remote control adaptable (remote
control sold separately).
canopy
page 6
ground
(green or bare)
ground
(green
or bare)
*
hanging bracket
slotted
hole