Safety And General Information; Product Description - Fastenal EQUIPRITE 5100790 Manual De Instrucciones Y Partes

SaFetY and GeneRaL InFORMatIOn

Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.

PROdUct deScRIPtIOn

This Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads must be
supported by a pair of appropriately rated jack stands. This service jack has a unique feature that provides fast, no
load lifts to the jacking point, at which time it lifts in approximately 0.75 ~ 2" increments.
!
NEVER use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle with
a pair of appropriately rated jack stands. NEVER place ANY portion of your body beneath the vehicle when
lifting OR lowering!
SPecIFIcatIOnS
Model Capacity
5100790 3 Ton
release valve gear
assembly
Jack Size (L x W x H)
27-1/2" x 13-3/8" x 6-3/8"
oil filler plug (on reservoir,
not shown)
handle sleeve
Figure 1 - Model 5100790 Components
Min. Height
5-3/4"
handle grip
(turn clockwise to lift, counter-
clockwise to lower saddle)
pump handle
rear caster
2
Max. Height Saddle Dia.
19-7/8" 5-1/2"
saddle
front wheel