Fastenal EQUIPRITE 5100790 Manual De Instrucciones Y Partes página 3

PREPARATION
assembly
Insert handle into the handle sleeve. Tighten the bolt on handle sleeve to prevent accidental removal of handle while
in use.
Before Use
1. Verify that the product and application are compatible, if in doubt contact your local Fastenal Representative or
visit www.fastenal.com to locate your nearest store.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, locate and turn the release valve (handle):
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the saddle.
b. Counter-clockwise, but no more than 1/2 a turn from the closed position. This is the 'OPEN' release valve
position used to lower the saddle.
4. With saddle fully lowered, remove the oil filler plug. *Pump 6 to 8 full strokes. Check oil level. Proper oil level will vary
from just covering the ram cylinder to 3/16" above it as seen from the oil filler hole. Reinstall the oil filler plug.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into
service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with factory
authorized replacement parts only.
*Bleeding / venting trapped air
With the release valve in the OPEN position (3b.) and with saddle fully lowered, locate and remove the oil filler
plug. Pump 6 to 8 full strokes. This will help release any pressurized air which may be trapped within the reservoir.
Reinstall the oil filler plug.
WARNING
!
• Study, understand, and follow all printed
materials provided with/on this product before use.
• do not exceed rated capacity.
• Use only on hard, level surface.
• this is a lifting device only!
• Immediately after lifting, support the load with
a pair of appropriately rated jack stands.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• do not move or dolly the vehicle while on the jack.
• No alterations shall be made to this product.
• Failure to heed these marking may result in
personal injury and/or property damage.
WARNING
!
To avoid crushing and related injuries:
• never work on, under or around a load supported
only by hydraulic jack.
• always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
3
X