Fastenal EQUIPRITE 5100790 Manual De Instrucciones Y Partes página 4

OPeRatIOn
Lifting
! Only attachments and/or adapters supplied by the manufacturer shall be used. Lift only on areas of the
vehicle as specified by the vehicle manufacturer.
1. Follow the vehicle manufacturer's recommended guidelines for lifting. Engage the emergency brake and chock
each unlifted wheel in both directions to prevent inadvertent vehicle movement.
2. Close the release valve by turning the handle clockwise until firm resistance is felt.
3. Refer to the vehicle manufacturer owner's manual to locate approved lifting points on the vehicle. Center jack
saddle under lift point.
4. Verify lift point, then pump handle to contact lift point. To lift, pump handle until load reaches desired height.
5. Transfer the load immediately to appropriately rated jack stands.
!
NEVER use hydraulic jack as a stand alone device! ALWAYS transfer the lifted load IMMEDIATELY to a
pair of appropriately rated jack stands. Use one pair of jack stands per vehicle. Rated capacity is per
pair only! Do not exceed rated capacity.
Lowering
! Be sure all tools and personnel are clear before lowering load. Slowly open the release valve! The more
you turn the handle counter-clockwise, the faster the load will come down. Maintain control of the rate
of speed at which the load lowers at all times!
1. Raise load high enough to clear the jack stands.
2. Remove jack stands carefully.
3. Slowly turn the handle counter-clockwise, but no more than 1/2 a turn. If the load fails to lower:
a. Use another jack to raise the vehicle high enough to reinstall jack stands.
b. Remove the malfunctioning jack and then the jack stands.
c. Using the functioning jack to lower the vehicle.
4. After removing jack from under the vehicle, fully lower the saddle to reduce ram exposure to rust and
contamination.
MaIntenance
Important: Use OnLY good grade hydraulic jack oil. Avoid mixing different types of fluid and never use brake fluid,
turbine oil, transmission fluid, motor oil or glycerin. Improper fluid can cause failure of the jack and the potential for
sudden and immediate loss of load. We recommend Mobil DTE 13M.
adding oil
1. With saddle fully lowered set jack in its upright, level position. Locate and remove oil filler plug.
2. Fill with oil until ~3/16" above the inner cylinder as seen from the oil filler hole. Reinstall the oil filler plug.
changing oil
For best performance, replace the complete fluid supply at least once per year.
1. With saddle fully lowered, remove oil filler plug.
2. Lay the jack on its side and drain the fluid into a suitable container.
note: Dispose of hydraulic fluid in accordance with local regulations.
3. Fill with oil until ~3/16" above the inner cylinder as seen from the oil filler hole. Reinstall oil filler plug.
4