Technical Specifications; Safety Instructions - Trixie REPTILAND Guia De Empleo

flame resistant surfaces (not flammable surfaces!).
Improper use or mounting is not permitted!
Use in a Terrarium:
The installation inside a terrarium is at your own risk.
As the company TRIXIE has no influence over the
operating conditions in the terrarium, it is the respon-
sibility of the consumer to ensure safe and appropriate
conditions for use.
Initial Operation and Operation:
• Before the first use, insert a bulb into the E27
socket and plug the mains plug into a suitable
plug socket.
• Ensure adequate ventilation to help prevent small
areas overheating.
• Switch the lamp on and off with the switch on the
power cable.
• When installing the lamp with a clamp fixture,
ensure that the lamp is fixed securely. The lamp
must not be attached to pipes!
Terrarium inhabitants must have the opportunity to
retreat out of reach of the lamp. Temperature gradi-
ents and places to retreat to are essential parts of a
terrarium habitat and help improve the well-being of
your pets. Please follow the manufacturer's instruc-
tions when using bulbs with UV radiation.

Safety Instructions:

• Do not hang the lamp on the power cable without
installing the pull-relief.
• Regularly check the holder, power cable, switch
and plug for signs of damage. If signs of damage are
found, switch the lamp off immediately and do not
use it any more. The same applies if the bulb comes
into contact with liquids. Check-ups or repairs must
be carried out by a qualified electrician!
• Before implementation, it is advisable to check
that this device is suitable for the required use. If
you have any questions, please consult an expert
or the manufacturer.
• Do not use the lamp in humid environments.
• Disconnect the electrical supply before changing
the bulb.
• Ensure that the hottest parts of the lamp are not
touched.
• The lamp must only be used on flame resistant or
inflammable surfaces and not covered, for exa-
mple, with a blanket. Risk of fire! Flame resistant
surfaces must have an ignition temperature of at
least 200°C and must not soften or deform. For
example, they may consist of wood or wood-based
materials over 2 mm thick.
• Only use the power cable provided by the manuf-
acturer to connect the lamp. If a damaged power
cable needs to be replaced, only use a special
cable, or one obtained from the manufacturer. An
inspection must be carried out by an expert after
inserting/replacing the power cable, before the
next use of the lamp.
• Do not use UV bulbs in rooms with human access.
Do not look directly at the lamp.

Technical Specifications:

Operational Voltage
230 V~50/60 HZ
Switching Current
max. 1,3 A
Maximum Ambient Temperature
45 °C
Maximum Input Voltage
160 W
Safety Distance
Consult the manufacturer's information for the
relevant bulbs.
Suitable Bulbs:
The following bulbs are suitable for use with this
product:
• reflector bulbs (filament) and light bulbs (e.g. 'REP-
TILAND Basking Spotlight) up to 160 W
• self ballasted UV-lamp (e.g. 'REPTILAND ProSun
Mixed D3') up to 160 W
• UV compact bulbs (self-ballasted energy saving
bulbs e.g. 'REPTILAND Tropic Pro Compact') up
to 23 W
• ceramic heat spotlights with E27 sockets (e.g.
'REPTILAND' Ceramic Infrared Basking Spotlight)
up to 160 W
Please adhere to the instructions for use and data spe-
cifications of the bulbs, especially the recommended
safe distances for spotlight surfaces.
5