Mopar 82210984 Serie Instrucciones De Instalación página 7

d. Remove the front portion of the connector from
the connector housing. This portion of the
connector aligns the terminals properly within the
connector housing.
e. Route the Purple/White wire from the
hood switch harness through the secondary
lock, through the weather seal and into the
terminal 3 (G70 circuit) slot of the connector
housing.
Pin 3 (G70 circuit)
f. Reinstall the front portion of the connector,
observing that all terminals are seated correctly and are in
the right direction. Reinstall the weather seal and
the secondary lock.
g. Reinstall the connector into the TIPM.
Wire End View
7 of 10