Installation Procedure - Mopar 82210984 Serie Instrucciones De Instalación

Validation Process
1. Press ----- ECU VIEW
2. Toggle down and highlight ----- TIPMCGW CENTRAL
3. Press ----- MORE OPTIONS
4. Press ----- ECU DETAILS
5. Press ----- CONFIG INFO
6. Toggle down, verify:
Name
REMOTE START PRESENT

Installation Procedure:

Disconnect Ground From Battery
1. Remove ground from battery
a. Using a 10 mm socket, remove the negative battery cable.
This vehicle may be equipped with a "Factory Installed" hood switch harness. This har-
ness will not be visible but will be secured to the factory harness located just below the
TIPM. If this harness is present, Refer to step "a" in the "Hood Switch Harness Installa-
tion" section below and connect the hood pin switch as described, then proceed to "Re-
mote Start Antenna Installation" and continue with this instruction manual. If this vehicle
DOES NOT have a factory installed hood switch harness (one is supplied in the kit), pro-
ceed with the complete "Hood Switch Harness Installation" procedure.
GATEWAY
Value
SET
Factory Harness
Location
4 of 10