Cequent Performance Products 36592 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
Figure 2
1. Fascia removal – use flat head screwdriver and 10mm socket to remove (2) rivets and (2) plastic caps from bottom fascia, see Figure 2. Use T15 driver and 7mm socket to remove (5) screws from wheel
well each side, see Figure 3. Open the trunk and gently remove the fascia. Carefully set the bumper fascia aside.
2. Bumper beam removal – use 16mm socket to remove (2) flange nuts and (2) bolts from bumper plate each side, see Figure 4. Gently remove bumper beam and exhaust rod hanger. Use a support to keep
muffler from getting damaged.
3. Hitch installation – raise the hitch and align top 2 holes on the hitch to the studs on the end panel. Raise the bumper beam and exhaust rod hangers to sandwich the hitch, see Figure 1. Reuse the flange
nuts and bolts to loosely fasten them.
4. Tighten all fasteners with torque wrench to 53 Lb.-Ft. (72 N*M).
5. Bottom fascia trimming – locate the center of bottom panel and trim 13.5'' tall by 3'' wide area, see Figure 5. Make additional trimming if needed.
6. Reinstall all fasteners and fascia removed in Step 1, 2.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been
damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 36592, 06170
Reuse all
fasteners
from bumper
attachments
Rear
Bumper
beam
Figure 1
Proper torque is needed to keep the hitch secure to the vehicle when towing.
(Sold separately)
Drawbar Kit: 36071
Drawbar must be used in
the RISE position only.
Bumper
end panel
Exhaust rod
hanger
Sheet 3 of 12
Figure 3
Figure 4
3''
Figure 5
36592NP 01-29-16
13.5''
Rev. A