Important Remarks; Eu Declaration Of Conformity - V2 DEV-T1 Guia De Inicio Rapido

DESCRIPTION
The DEV-T1 module is a transmitter powered by mains voltage.
The container's reduced dimensions permit easy insertion of the
module into the electric junction boxes.
• Power supply with extended range: 85 ÷ 260 Vac - 50/60 Hz
• Very low power consumption in stand-by
• 4 N.O. wired inputs for buttons
SPECIFICATIONS
Power supply ______________________85 ÷ 260 Vac - 50/60 Hz
Frequency _________________________434,15 MHz
Consumption in stand-by _________ 0,15 W
Operating temperature ___________ -20 ÷ +60 °C
Maximum operating time _________ 120 s
Protection ______________________ IP10

IMPORTANT REMARKS

• Attention: for people safety it is important to follow carefully
the instructions. Keep the instructions.
• Important safety instructions for the installation.
Attention: a wrong installation can cause serious accidents.
Follow carefully the installation instructions .
• This device can be installed only from qualified persons.
• The control buttons and the connection cables shall have
insulation properties suitable for electrical installations with
operating voltage of not less than 300Vac
• In order to protect the device, the installer must provide for
a magnetotermical differential switch (separation among the
contacts: at least 3 mm), ensuring the omnipolar sectioning
from the power supply.
• The device must be installed only inside a junction box or wall
box.
• The device container does not provide any protection
against water. Thus, it should be installed only in protected
environments.

EU DECLARATION OF CONFORMITY

V2 S.p.A. hereby declare that DEV-T1 products conform to the
essential requirements established in the following directives:
- 2014/30/UE (EMC Directive)
- 2014/35/UE (Low Voltage Directive)
- 99/05/CEE (Radio Directive)
- ROHS2 2011/65/CE
Racconigi, lì 01/06/2019
V2 S.p.A. legal representative
Sergio Biancheri
WIRING (FIG.2)
P1 UP button input
P2
STOP button input
P3 DOWN button input
P4
Code storage stage activated
N Power supply neutral
L
Power supply phase
Pressing the three buttons in combination allows to activate the
following functions on the control unit:
P2 + P1 - Sun sensor activated
P2 + P3 - Sun sensor disabled
P1 + P3 - STOP command
NOTE: you must hold the buttons pressed until the control unit
signals it has received the command by running the motor or
activating the relays.
- 4 -