Publicidad
Idiomas disponibles
Idiomas disponibles
1. After the RF-Hub has been replaced with new unit, connect the diagnostic scan tool to the
Data Link Connector (DLC). You may have to manually enter the VIN.
2. Navigate to the RF-Hub (RFH) in the "Vehicle View" of the diagnostic scan tool.
3. With the scan tool, select “RF-Hub,” then the “Misc. Functions” tab and perform the
“RF-HUB Replace” routine.
4. Select “BCM Misc. Function” and perform the “PROXI Configuration Alignment” routine.
5. Remove pod from the vehicle and allow the BUS to go into Sleep MODE for approx. 5 minutes.
6. Place all fobiks inside the vehicle near the center console.
7. Reinstall Pod and connect scan tool. With the scan tool, select: "Program ignition FOBIKs" in the
Miscellaneous Functions menu and follow the WiTECH prompts on screen.
8. Turn the ignition to the OFF position, remove Pod. Wait 5 minutes, then cycle the ignition back
to the ON/RUN position.
9. Reinstall Pod, connect the scan tool and select “RFH”
10. In the miscellaneous functions tab, update the Front and Rear Axle Normal Tire Pressure Values
by entering placard values.
11. Program the Tire Sensor IDs using the information recorded earlier.
12. Check and clear any active DTCs.
13. Test drive vehicle 5 miles and reach a minimum 35mph to activate the Remote Start.
With the vehicle off, and the doors closed and locked, check all FOBIC functions and verify the remote
start is functioning properly.
4-11-17
www.mopar.com
14
Publicidad
