Publicidad
Idiomas disponibles
Idiomas disponibles
1. Log on to https://dealerconnect.chrysler.com.
2. In the "Service tab"-"Warranty Administration" box -"Vehicle Option Updates" screen, enter the vehicle
VIN and add the sales code XBM (Remote start) as a "Dealer Installed Option".
3. Confirm that the new sales code has been successfully added to the VIN.
1. With the WiTECH diagnostic application, perform the following steps:
2. Select the “RF HUB MODULE.”
3. Select the “Data” tab.
4. Write down the names and data values for each of the Tire Sensor ID’s. This will be needed later
in the installation procedure.
1. With the WiTECH tool connected to both the Internet (via Ethernet port or wireless connection) and the vehicle,
follow the steps below:
2. Place the ignition into RUN using one of the existing FOBIKS.
3. Use the WiTECH tool to run “Restore BCM Proxi Configuration” which can be found in the VEHICLE PREPARATION
tab of the main topology screen. Following the prompts will upload the new vehicle PROXI configuration
to the BCM.
4. Continue following the prompts on the WiTECH tool until the application restarts and takes you to the
Connection Wizard screen.
5. Perform the PROXI Configuration Alignment Procedure under BCM Miscellaneous Procedures.
6. Remove pod from the vehicle and allow the BUS to go into Sleep MODE for approx. 5 minutes.
7. Re-establish connection with the vehicle using WiTECH.
8. Clear all DTCs.
9. Close WiTECH tool, turn ignition off, then proceed to disconnect battery.
4-11-17
www.mopar.com
2
Publicidad
