peerless-AV SC550 Instalación Y Ensamblaje página 9

For Flat Back Display
Begin with the shortest length screw, hand thread screw through multi-washer and display brackets (B) into
6-1
display as shown. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with the longest length screw, hand thread screw through multi-washer, display brackets (B) and spacer
6-2
in that order into display as shown. Screw must make at least three full turns into the mounting hole and fit snug
into place. Do not over tighten. If screw cannot make three full turns into the display, select a shorter length screw
from the baffled fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
DISPLAY
SPACER (HH)
9 of 35
MULTI-WASHER (GG)
SCREW
(AA,CC,EE)
UNIVERSAL ADAPTER
PLATE (B)
MULTI-WASHER (GG)
SCREW
(BB,DD,FF)
UNIVERSAL ADAPTER
PLATE (B)
ISSUED: 02-25-11 SHEET #: 009-9048-3 09-09-13