Publicidad
Idiomas disponibles
Idiomas disponibles
A. LINE CORD - The power line
cord must be connected to a
grounded AC receptacle in
accordance with the voltage and
frequency ratings as listed on
the rear panel under INPUT
POWER.
B. FOOTSWITCH - Plug-in con-
nection for the optional remote
footswitch (P/N 037659) used to
switch
ON/OFF
the
effect. Using this jack will over-
ride the chorus select switch on the front panel. NOTE: Any good qual-
ity patch cord will work with the remote footswitch, however an
unshielded speaker type cord is preferable to a coax guitar cord.
C. RETURN - This 1/4-inch, stereo, TRS (Tip=Left, Ring=Right,
Sleeve=Ground), line-level input jack is designed to accept signal from
an external processing device, such as a digital delay or a chorus unit.
TYPE:
PART NUMBER:
POWER REQUIREMENTS:
POWER AMPLIFIER SECTION
POWER OUTPUT:
SENSITIVITY :
PREAMP SECTION
INPUT IMPEDANCE:
SENSITIVITY FOR FULL POWER: 12.75mV (Inst),
TONE CONTROLS:
FEEDBACK NOTCH:
STRING DYNAMICS:
PHANTOM VOLTAGE:
SPEAKER COMPLIMENT:
DIMENSIONS:
WEIGHT:
R R
e e
a a
r r
P P
a a
n n
R R
e e
a a
r r
P P
a a
n n
B
A
chorus
S S
p p
e e
c c
i i
S S
p p
e e
c c
i i
PR 334
022-1302-000 (120V, 60Hz) USA
022-1342-000 (230V, 50 Hz) UK
022-1372-000 (100V, 50/60 Hz) Jpn
300W
40W R.M.S. per channel, (80W R.M.S. Total)
into 8Ω @ <.12% T.H.D., both channels driven
640mV @ stereo effects return (both channels)
10MΩ (Inst),
Treble:
Mid:
Bass:
-10dB from 80Hz to 700Hz
0 to -15dB @ 6.3kHz
+15V DC (Mic)
Two Fender Special Design 8" speaker (P/N 051016)
Single Piezo Horn (P/N 049260)
Height:
Width:
Depth:
Product specifications are subject to change without notice.
e e
l l
F F
u u
n n
c c
t t
i i
o o
n n
e e
l l
F F
u u
n n
c c
t t
i i
o o
n n
D. SEND - This 1/4-inch, stereo, TRS,
C
D
E
E. INSTRUMENT INSERT -
f f
i i
c c
a a
t t
i i
o o
n n
s s
f f
i i
c c
a a
t t
i i
o o
n n
s s
3.6kΩ (Mic),
5mV (Mic),
+/-15dB @ 15kHz (Inst),
+/-12dB @ 1kHz (Inst)
+/-12dB @ 100Hz (Inst),
15.5 in
(39 cm)
22.4 in
(57 cm)
10.2 in
(26 cm)
43 lb
(19.5 kg)
7
s s
s s
line-level output jack is designed to
feed the Acoustasonic Junior's
effects bus to an external signal
processing device, such as a digital
delay or a chorus unit.
Acoustasonic Junior, the tip is left
and the ring is right. This jack can
also be used as a line out.
1/4-inch, unbalanced, input/output,
line-level phone jack is designed
for use with a signal processing
device, such as a digital delay or
Reverb unit. A special "Y" line cord
(stereo to dual mono) is required to
use this TRS jack (Tip=Send,
Ring=Return, Sleeve=Ground).
022-1332-000 (240V, 50 Hz) Aust
022-1362-000 (230V, 50 Hz) Eur
36.4kΩ (Line/Inst)
50mV (Line/Inst)
+/-15dB @ 15kHz (Mic, Line/Inst)
+/-12dB @ 50Hz (Mic, Line/Inst)
On the
This
Publicidad
