Velleman VM161 Manual Del Usuario página 5

VM118R remote control setup
1. First connect the RGB led-strip to the controller VM161, see page 2.
2. Place 3 AAA battery's in the remote control
Note: All settings remain in memory after battery replacement
3. First-time configuration of the remote control for use with the VM161 controller
keep button 'on/off' pressed until the led lights
briefly press button '1'
briefly press button '8' (the led will blink once)
press button 'on/off' twice to confirm the setting (the led will turn off)
Insert the batteries in the battery
compartment as indicated in figure
and close the compartment.
Remark : Respect your
national and local laws
when disposing of empty
batteries.
1
3
5
7
Operation
LED
2
4
6
8
On / Off
5