Fuse Replacement - Steren MUL-400 Manual De Usuario

testing points are disconnected to avoid the risk of electrical
shock.
1.- If the battery icon displays in the screen, you must replace
the battery.
2.- Remove the back cover.
3.- Replace the battery with a new one.
4.- Replace the battery cover.

FUSE REPLACEMENT

Warning
Before removing the cover from your multimeter, make sure the
testing points are disconnected to avoid the risk of electrical
shock.
If these need to be replaced make sure to use a fuse of the same
model and with the same characteristics (F1: F 200 mA / 250 V
fast response, <2 Ohms, F2: F 10 A / 250V fast response).
1.- The fuse rarely needs to be replaced and when it does, it is
usually due to an error in operation.
2.- To replace the fuse, remove the cover from the multimeter
removing the three screws on the back of the multimeter.
REPLACING THE TESTING POINTS
Warning
The complete satisfaction of accurate readings can only be
guaranteed using the included testing points. If these need to be
replaced make sure to use testing points of the same model and
with the same characteristics (1 000V 10A).
ACCESSORIES
• User's manual
• Testing points
• Battery (included)
• Thermo-pair type "K"
• Case
• Multifunctional connector
The characteristics for this multimeter are subject to change The characteristics for this multimeter are subject to change
without notice. without notice.
ENGLISH-13