Name Of Each Part Of Projector; Setting-Up Projector - Christie LX120 Guía De Referencia Rápida

NAME OF EACH PART OF PROJECTOR

FRONT OF CABINET
INFRARED
REMOTE RECEIVER
PROJECTION LENS
LENS CAP
CAUTION
Do not turn on a projector with lens cap
attached. High temperature from light beam
may damage lens cap and result in fire hazard.
BACK OF CABINET
EXHAUST VENT
HOT AIR EXHAUSTED !
Air blown from exhaust vent is hot.
When using or installing a projector,
following precautions should be taken.
● Do not put a flammable object near this
vent.
● Keep rear grills at least 3.3' (1m) away from
any object, especially heat-sensitive object.
● Do not touch this area, especially screws
and metallic parts. This area will become
hot while a projector is used.
This projector detects internal
temperature and automatically controls
operating power of Cooling Fans.
BOTTOM OF CABINET
AIR INTAKE VENTS
This projector is equipped with
cooling fans for protection from
overheating. Pay attention to
following to ensure proper
ventilation and avoid a possible risk
of fire and malfunction.
● Do not cover vent slots.
● Keep bottom clear of any objects.
Obstructions may block cooling air.
POWER CORD
CONNECTOR
MAIN ON / OFF
SWITCH
CARRYING HANDLE
LEVEL AND TILT ADJUST HANDLE
INFRARED
REMOTE RECEIVER
LAMP COVER
AIR FILTER
ADJUSTABLE FEET
ADJUSTABLE FEET

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD
This projector uses nominal input voltages of 120 V or
200-240 V AC. This projector automatically selects
correct input voltage. It is designed to work with single-
phase power systems having a grounded neutral
conductor. To reduce risk of electrical shock, do not plug
into any other type of power system.
Consult your authorized dealer or service station if you
are not sure of the of the power supply being in use.
Connect the projector with peripheral equipment before
turning the projector on.
CAUTION
AC Power Cord must meet requirement of country where you use a projector.
Confirm AC plug type with chart below and proper AC power cord must be used.
If supplied AC Power Cord does not match AC outlet, contact your sales dealer.
Projector side
For U.S.A. and Canada
To AC Outlet.
To POWER CORD
(120 V AC)
CONNECTOR on a
projector.
Connect the AC Power Cord
(supplied) to the projector.
AC outlet must be near this
equipment and must be easily
accessible.
AC Outlet side
For Continental Europe
Ground
To AC Outlet.
(200 - 240 V AC)