Attaching The Fan Blades - Hunter Clarington El Manual Del Propietario

CLOSE-TO-CEILING MOUNTING
1. Carefully unhook the fan from the mount-
ing bracket and align the locking slots of the
ceiling canopy with the two screws in the
mounting bracket. Push up to engage the
slots and turn clockwise to lock in place. Im-
mediately tighten the two mounting screws
firmly.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING. DO
NOT LEAVE FAN ASSEMBLY UNATTENDED UN-
TIL ALL FOUR CANOPY SCREWS ARE ENGAGED
AND FIRMLY TIGHTENED.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by align-
ing the ring's slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
4. You may now proceed to attaching the fan
blades.
Attaching the
Fan Blades
NOTE: Your fan blades are reversible. Select
the blade side finish that best accentuates your
decor.
8.
1. Attach blade to bracket using the screws
as shown in figure 13. Start a screw into
the bracket. Repeat for the two remaining
screws.
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
inserting the alignment post into the slot on
the bottom of the motor and tightening the
blade bracket screws. Please note that the
blade bracket screws are pre-installed into
the blade bracket (Figure 14).
4. Repeat steps 1-3 for the remaining blades.
FAILURE TO PROPERLY SEAT THE BLADES
ON THE BLADE BRACKETS AND ENGAGE THE
LOCKING MECHANISMS COULD RESULT IN
THE FAN BLADES LOOSENING AND POSSIBLY
FALLING.
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade and blade bracket
screws are secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on the
ceiling. Measure this distance as shown in
Figure 15. Rotate the fan until the next blade
is positioned for measurement. Repeat for
Figure 13
each blade. Measurement deviations should
within 1/8". Run the fan for 10 minutes.
3. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
Figure 14