Hunter Clarington El Manual Del Propietario página 11

TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
WAIT FOR FAN TO STOP BEFORE REVERSING
THE DIRECTION OF BLADE ROTATION.
Installing the Light
Kit/Glass Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
1. Remove two of four mounting screws and
lockwashers on the switch cup below the fan
motor assembly, loosen but do not remove
the other two mounting screws and lock-
washers (Figure 16).
2. Connect the blue and white wires exiting
the switch cup below the fan motor assem-
bly with the black and white wires from the
light kit assembly by connecting the polar-
ized plugs (blue to black; white to white).
Carefully push all wires back into the switch
cup.
3. Align the two key slots in the light kit as-
sembly with the two mounting screws and
lockwashers on the switch cup that were
loosened in step 1, place the light kit assem-
bly over the two screws, turn the light kit
assembly clockwise until it locks, tighten
Figure 15
the two screws.
4. Re-install the two mounting screws and
lockwashers that were removed in step 1
and tighten firmly.
5. Remove the finial, hex nut and rubber wash-
er from the threaded pipe of the light kit as-
sembly.
6. With power off, install the light bulbs (Max.
14w) into the sockets (Figure 16).
7. Position the glass bowl over the threaded
pipe of the light kit assembly, re-install the
rubber washer and hex nut that were pre-
viously removed to secure the glass bowl
properly. Re-install the finial and finger
tighten.
DO NOT OVERTIGHTEN THE HEX NUT
AND FINIAL, OVERTIGHTENING THE
HEX NUT OR FINIAL MAY CAUSE THE
GLASS TO BREAK.
Hex Nut
Figure 16
9.