Hunter Clarington El Manual Del Propietario página 9

4. Connect the fan motor blue wire to the re-
ceiver blue wire using a wire nut.
5. Connect the receiver red (or black) wire to
the supply black (hot) wire using a wire nut.
6. Connect the receiver white wire to the supply
white (neutral) wire using a wire nut.
7. After connecting the wires, spread them apart
so that the green and white wires are on one
side of the outlet box and black wire is on the
other side.
8. Turn the wire connecting nuts upward and
push the wiring into the outlet box.
EACH WIRE NUT (WIRE CONNECTOR) SUP-
PLIED WITH THIS FAN IS DESIGNED TO ACCEPT
UP TO ONE 12 GAUGE HOUSE WIRE AND TWO
WIRES FROM THE FAN. IF YOU HAVE LARGER
THAN 12 GAUGE HOUSE WIRING OR MORE
THAN ONE HOUSE WIRE TO CONNECT TO THE
FAN WIRING, CONSULT AN ELECTRICIAN FOR
THE PROPER SIZE WIRE NUTS TO USE.
ELECTRICAL DIAGRAMS ARE FOR REFERENCE
ONLY. OPTIONAL USE OF ANY LIGHT KIT SHALL
BE UL LISTED AND MARKED SUITABLE FOR
USE WITH THIS FAN.
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWN-
ROD MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling canopy
with the two screws in the mounting plate.
Push up to engage the slots and turn clock-
wise to lock in place. Immediately tighten
the two mounting screws firmly.
2. Install the
screws into the holes in the canopy and
tighten firmly.
3. Install the decorative canopy ring by align-
ing the ring's slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
4. You may now proceed to attaching the
fan blades.
Figure 12
remaining two mounting
7.