Programming Mode - Tefcold EV3B23 Manual De Usuario

Change the Set Point
Press this key once, the compressor LED will flash.
Down, lower the value displayed.
Up, increase the value displayed.
Press this key to confirm.

Programming mode

Press this key for 4 seconds 'PA' will be displayed.
Press this key once.
Use this or
this key to select password '-7'
Press this key once, 'SP' will be displayed.
Use this or
this key to select a parameter. See parameter list.
Modify a parameter
Press this key once, the value will be displayed.
Down, lower the value displayed.
Up, increase the value displayed.
Press this key to confirm.
Confirm all changes
Press this key for 4 seconds or leave the thermostat untouched for approx. 1 minute.
Switch the power supply Off/On to start using the modification.
7