KTM Power Parts SXS13450512 Instrucciones página 5

1
2
5
4
3
6
Scope of supply:
1x main silencer with spark arrestor insert (1)
1x thermal protection foil (2)
Main silencer fixation
2
- If necessary, attach thermal protection foil (2).
- Remove the standard silencer (see the Owner's Manual).
- Mount the rubber piece (3), large bushings (4) and small bushings (5) of
the original main silencer.
NOTE:
Mount the small bushings (5) on the inside of the main silencer.
- Position the FMF
- Attach the exhaust spring (6) (included).
- Set up the entire exhaust system and tighten all fixing screws.
When using the main silencer for the first time, the engine rpm must be kept
low for roughly the first 5 minutes to evenly heat the main silencer. This ensu-
res that the rock wool will be fully effective and will be able to keep the volume
down to the required level.
and attach it using the original screws.
factory silencer
5