Device Care And Storage; Use While Traveling; Troubleshooting Information - CMF OL1000 Manual Del Usuario

Device Care and Storage

• If needed, clean the surface only with a damp cloth.
• Always store the device in its carrying case in a cool, dry
place . never keep it where the temperature is less than 5°F
(-15°C) or greater than 140°F (60°C) . Temperatures below or
above could damage the device .
• never store the device or any of its parts in an automobile in
cold or hot weather .
• Always store the OL1000 or OL1000 SC in the carrying case
provided with the device . The carrying case will protect the
device when not in use . It also stores the extra batteries and
this manual .
• To avoid the risk of choking or strangulation, always store
the OL1000 or OL1000 SC in its carrying case out of reach of
small children .

use While traveling

You should try to use the OL1000 or OL1000 SC at the same
time every day . The clock inside the device counts each
day starting at midnight Pacific Standard Time (PST), 8:00
AM Greenwich Mean Time (GMT), or 7:00 AM (GMT) during
daylight savings, and will only allow one treatment every 24
hours . If you travel outside of your normal time zone, you
should try to treat at the same time you normally would at
home . Do not take the OL1000 or OL1000 SC through airport
x-ray machines because the x-rays may damage the device .
12

troubleshooting information

60°C
-15°C
If you hear beeps before your 30-minute treatment is complete,
there may be a problem with your device . Look at the LCD
screen for a picture . Table 1 below shows pictures that may
appear on the LCD screen and other common problems (left
side of table) . The action to take for each picture or problem is
on the right side of the table .
Table 1 . Display Messages
(Troubleshooting continues on page 14)
Display Picture
Magnetic Interference – announced
by three beeps . The "X" will flash .
1 . If the device looks damaged, call
Customer Care .
2 . If not, try moving to another
location in your house . Make sure
you are not near metal objects .
3 . If the picture is still displayed,
replace the batteries with new ones .
4 . If the device still shows the
picture, call Customer Care .
Replace Battery – announced by
three beeps .
Replace the batteries with new ones .
Phone For Help – announced by
three beeps .
Call Customer Care .
action to be taken
13