Fanimation The Cumulos Manual Del Propietário página 5

How to Assemble Your Ceiling Fan (cont'd)
3. Fasten Cable Hanger to Support Arm with screw
provided, 3 places. (Figure 3)
4. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 4) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 8.
5. The fan comes with blue, black, white 80˝ wires and
support cable. Separate and untwist the three wires and
support cable. Route the wires through the Downrod.
NOTE: You will be using either the 6˝ or the optional
downrod purchased separately.
6. Loosen the three setscrews in the Downrod Support.
Align the Clevis Pin holes in the Downrod with the holes
in the Downrod Support. Install the Clevis Pin and secure
with the Hairpin Clip. (Figure 5) Be sure to push the
straight leg of the hairpin clip through the hole near the
end of the clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip must be
properly installed to prevent the clevis pin from working
loose. Pull on the Downrod to make sure the clevis pin is
properly installed.
7. Route wires and support cable through Motor Coupling
Cover and through opening in Canopy Screw Cover and
Canopy. Position Canopy Screw Cover and Canopy on
fan shown with open side facing up. (Figure 6)
8. Reinstall the Hanger Ball (Figure 4) on the Downrod
as follows. Route the three 80˝ wires and support cable
through the Hanger Ball. Position the Pin through the two
holes in the Downrod and align the Hanger Ball so the Pin
is captured in the groove in the top of the Hanger Ball. Pull
the Hanger Ball up tight against the pin. Securely tighten
the setscrew in the Hanger Ball. A loose setscrew could
create fan wobble.
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
Pin
Hanger
Ball
Clevis Pin
5
Figure 3
Setscrew
Figure 4
Motor
Coupling
Cover
Hairpin Clip
Screw (3)
Figure 5