Horizon Global 76227 Instrucciones De Instalación página 4

1. Remove Tail Lights- a) Open the lift gate.
b) Remove the plastic tail light cover buy using a Flat Head and a Phillips Head screw driver to remove (2) screw type push pins (each side).
c) Using a 10mm Socket remove (2) screws from the tail light (each side).
d) Pull the tail light rearward and remove (2) bulbs and (1) electrical connector from the tail light assembly (each side).
2. Remove Fascia -*NOTE- Save all fasteners for reinstallation. a) Remove (1) push pin from the wheel well. (each side) Using a Phillips Head screw driver push on the center of
the push pin and then remove. *NOTE- If mud flaps are installed at the bottom of the wheel well and fascia using a Phillips Head screw driver remove (3) screws , using a Flat
Head screw driver remove (2) push pins (each side).
b) Using a Flat Head screw driver remove (7) push pins along the bottom edge of the fascia.
c) Using a Flat Head screw driver open the tab on the facia under the tail light. Using a 10mm socket remove (1) screw (each side)
d) Starting at the wheel well gently pull the fascia rearward and set aside.
a
©2018 Horizon Global™ Corp. - Printed in Mexico
a
a
b
a
c
Sheet 4 of 18
b
76227NP 05-08-18
c
d
Rev. B