Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
27
3/8-16 x 4 1/2 Hex Head Bolt
3. Attach Strut Tubes (#17) and White Linkages (#16) to Caster Beam Assemblies (#7) as shown in Figure 2.
a) If necessary loosen Bolts (#13) and Nuts (#28) so that Strut Tube (#17) can fit between Support Plate (#43) and Caster Beam (#7)
as shown in the Top View and Figure 2.
b) Slide one Hex Bolt (#27) through one linkage (#16) one Spacer (#36) pass through Caster Beam (#7), followed by one Plastic
Washer (#39), Strut Tube (#17), another Plastic Washer (#39), inner Support Plate (#43) and Lock Nut (#28).
c) Repeat on other end of Caster Beam (#7) and on second Caster Beam.
d) Tighten Nuts (#28) on Bolts (#13) securely.
e) Tighten Nuts (#28) on Bolts (#27) securely.
NOTE: Tighten nuts so that end of Bolt (#27) in even with the edge of nut.
Note: Linkages & Strut
tubes must be turned as
shown or table will not
operate correctly.
Figure
2
7
27
HARDWARE NEEDED
(Qty. 4)
16
39
43
13
36
28
36
3/8-16
Locknut
(Qty. 4)
17
7
28
4
39
3/4" Long Spacer
(Qty. 4)
Washer (Qty. 8)
TOP VIEW
28
(Inner Plate)
43
28
39
12
13
7
36
27
3/8" Plastic
17
16
Publicidad
Tabla de contenido
