Stiga T8743 Manual Del Propietário página 5

4. Rotate U-support (#21) that is on bottom of Table Top until you see the screw holes in the slots of U-clips (#22).
If necessary Slide U-support (#21) side to side and back and forth to see holes. See Figure 3 & Detail A.
NOTE: To aid in assembly use a cordless drill but DO NOT over tighten screws. Wear safety glasses.
5. Insert Screw (#35) through slot in U-clip (#22) and into U-support (#21). See Figure 3 & Detail A.
Thread screw all the way into U-support until it touches the back of the tube. There should be about
3/8" of screw (#35) left sticking out. Repeat for second Screw (#35) and U Clip (#22).
6. Attach nut (#46) to leveler (#26) and screw all the way into leg as shown in Detail 1.
7. Repeat steps 4-6 on other table top assembly.
NOTE: Prepare an area for the assembly of the second table top half. If necessary, move
the first table top half aside with the aid of a helper. Be sure to place it in a location
where it won't be disturbed or damaged. If setting on its side, be sure to place the
bottom edge no less than 12 inches away from the wall. Also be sure to place carpet or
pieces of the shipping carton down to protect table top edges. If floor is not carpeted,
brace table top half with a heavy object to keep it from sliding.
If you want to see a video on how to insert Screw (#35) go to:
http://www.escaladesports.com/customer-service/instruction-videos
Or
Scan with your smartphone:
Note: Slide U-Support back and forth
until you see the hole if necessary.
35
22
Detail A
21
5
HARDWARE NEEDED
35
#8-32 X 1 1/4
Sheet Metal Screw
(Qty. 2)
Figure
3
21
U-Support
35
Table Top
Assembly
Detail 1
46
26