Stiga T8743 Manual Del Propietário página 8

30
1/4-20 X 1 1/2 Phillips
Truss Head Screw
(Qty. 2)
NOTE: Due to shipping requirements the hinge (#18) may be positioned as shown in
Detail B, if so you will have to rotate the hinge to the position shown in Detail C. DO
NOT unscrew the hinge, you can rotate the hinge without unscrewing it from the table.
11. Attach Hinges (#18) to Strut Tubes (#17) as shown in Figure 6 & Detail C. With hinge positioned
as shown, align hole in hinge with hole in Strut Tube and attach with ¼" Screw (#30), Plastic Washer
(#38) and Locknut (#34). Plastic Washer (#38) goes between Strut Tube and Hinge. Tighten nut
securely. Repeat for other Hinge. CAUTION: Hinges must be positioned exactly as shown or
table will not operate correctly and could be damaged. DO NOT take hinges off.
12. With at least two adults, repeat steps 8 through 11 for other table top assembly.
If you want to see a video on how to attach hinges to Strut tube go to:
http://www.escaladesports.com/customer-service/instruction-videos
30
HARDWARE NEEDED
34
1/4-20 Locknut
(Qty. 2)
Figure
6
17
17
34
38
18
Hinge Assembly
38
1/4" Plastic
Washer
(Qty. 2)
30
38
8
DO NOT OPEN THE TABLE TO PLAYING
POSITION UNTIL BOTH TOPS ARE
INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS
BODILY INJURY OR PROPERTY DAMAGE.
Or Scan QR code with
your smartphone:
ATTENTION: If hinge is positioned as
shown below (Detail B), Rotate the hinge as
shown in Detail C. Do not take hinge off.
18
Detail B
Shipping position
of hinge
CAUTION: Position Hinges exactly as
shown in Detail C or table will not
operate correctly and could be damaged.
Detail C
34
18
Assembly position of hinge
with elbow pointing down.
In the correct position Hinge #18 will
look like a "V" when attached to Strut
Tube (#17).
17
30
38
17
Elbow