Operation And Maintenance - Gorenje Tiki OGB 30 SEDD/UNI Instrucciones

Legend:
1 - Electronic thermostat
2 - Bipolar thermal fuse
2 - Electric heater (2x1000 W or 3x700 W)
4 - Connection terminal
L - Live conductor
N - Neutral conductor
- Earthing conductor
CAUTION: Prior to each reach in the inner of the water heater it must absolutely be
disconnected from the electric network!

OPERATION AND MAINTENANCE

After connecting to water and power supply, the heater is prepared for use.
The water heater features an that enables of water temperature of in water heater tank. The
electronic regulator allows manual adjustment of temperature in range from 35ºC to
settings to cost saving operation mode and temperature adjustment to prevent freezing.
Electronic regulator display shows the current temperature of water in water heater.
OPERATION CONTROL:
The heater is switched ON and OFF by pressing the
Continue pressing the
- protection against freezing (factory water temperature set to 7ºC)
- cost saving operation (factory set to 55ºC)
- optional manual setting of temperature in the range from 35ºC to 75ºC (increments of
1ºC)
key and select the three operating modes:
Electric installation
key for 2s.
75ºC,
13