Use And Operation; Cleaning And Care - Klarstein 10030485 Manual De Instrucciones

Before first use, clean the Bowl and Lid by removing Lid from Bowl and wiping both with a
moist, non-abrasive sponge, towel or cloth. Dry thoroughly with a non-abrasive dry towel.
Remove the Stirring Rod from the Base by turning Center Knob counterclockwise. Wipe the
Stirring Rod and Base with a moist, non-abrasive sponge, towel or cloth and then wipe with a
non-abrasive dry towel. Replace the Stirring Rod and make sure the rod fits into the notched
area around the screw. Secure by turning Center Knob clockwise.
1. First, find a flat surface near an electrical outlet before starting. Make sure your cord is
away from any water source. It is acceptable to use an extension cord if needed.
2. Gather your popcorn making supplies: popcorn, seasonings, cooking oil, and measuring
spoon for oil.
3. Measure 3 tablespoons of oil and add to the nonstick Base.
4. Using the Measuring Cup supplied with your POPCORN MAKER, add up to 6 ounces of
corn kernels. The Kernel Measuring Cup is 2 ounces, so you may £ll the Measuring Cup
3 times and place kernels in the nonstick Base. DO NOT exceed 6 ounces total of pop-
corn kernels.
5. For every Measuring Cap full of kernels (2 oz.), add 1 tablespoons of oil. For best results,
soft-shelled popping corn and vegetable oil is recommended.
6. Always remove Lid while kernels are popping. This will allow steam to vent through the
top.
7. Plug in the appliance while switch is ¤ipped to OFF position.
8. Turn appliance ON by ¤ipping the switch on the back of the Base. In no time at all, you
will hear the popping begin.
9. Once popping stops, turn unit OFF, then unplug.
10. Secure the Lid to the top of the Bowl.
11. While wearing oven mitts, ¤ip the Bowl over, remove Base and you will have hot, fresh
and delicious popcorn ready to serve!
NOTE:
If your POPCORN MAKER begins to smoke during cooking, it may be due to grease build
up. In order to reduce smoking, make sure that you clean the nonstick surface of the Base
between uses.
• Make sure appliance is unplugged and cooled before cleaning.
• Remove Stirring Rod from Base by unscrewing Center Knob. Wipe with a moist, non-
abrasive sponge, towel or cloth and dry.
• Wash the Bowl and Lid in warm, soapy water with a non-abrasive cloth or sponge. Rinse
thoroughly and dry with a non-abrasive towel.

Use and Operation

Cleaning and Care

8