Preventive Maintenance - Dri-Eaz TurboDryers Sahara E Manual Del Propietário

READ AND SAVE THESE INSTRUCTIONS
WARNING
ELECTRIC SHOCK HAZARD
Keep motor and electrical parts
dry.
Do not operate in standing water.
Do not expose to rain, water or
snow.
Do not get the exterior, motor or wir-
ing wet.
Do not clean with wet objects, i.e.,
power washers, soap and water, etc.
If motor or electrical parts become
wet, allow them to dry completely
before using.
Read and understand manual be-
fore operating.
WARNING
FIRE HAZARD
Keep air intakes clear. Reduced
airflow can cause motor to over-
heat.
Clean any lint or other material
from the screens before each use.
Do not operate near draperies or
other material that could block the
air intakes.
Clean dust and dirt from motor
using a vacuum or compressed air.
Do not use or store where flamma-
ble vapors like gasoline, solvents, or
thinners are present.
Do not use near open flames, or
heat sources.
Read and understand manual
before operating.
07-01534 Copyright 2006 Dri-Eaz Products, Inc.

Preventive Maintenance

Routine maintenance can significantly increase the life of your Tur-
boDryer. It also promotes efficient operation. The applications and
amount of use by owners vary, so the recommendations listed below
are for average-to high-volume use in water damage. Constant opera-
tion or use in other environments may require additional maintenance.
Contact Dri-Eaz for more information.
NOTE: Do not oil motor bearings; they are permanently oiled.
B E U :
EFORE ACH SE
•
Inspect power cord for cuts, fraying or damage; do not use if dam-
aged.
•
Remove lint or obstructions from the grills using a vacuum or com-
pressed air.
•
Inspect exterior components (switch, knob, etc.) for damage.
Q (
UARTERLY OR AS NEEDED
•
Clean the exterior with a household all-purpose spray cleaner.
Spray the rag, then apply to the surface.
•
To renew shine on the plastic, use a vinyl cleaner.
•
Remove grill and blower, then blow off internal components with
compressed air.
A :
NNUALLY
•
Inspect components and internal wiring for discoloration, loose con-
nections, or fraying.
A MICROBAN®
BOUT
MICROBAN® antimicrobial protection is built into products during the
manufacturing process, giving you antimicrobial protection that lasts for
the life of the product. MICROBAN antimicrobial protection inhibits the
growth of bacteria, mold and mildew that can cause stains, odors and
product deterioration. The continuous antimicrobial cleaning action
makes products easier to cleanse and keeps dirt and other buildup
away between cleanings. Normal cleaning practices should still be fol-
lowed as described above.
A Y U
PPLYING OUR NIQUE
•
Locate the smooth area on the front
side of the rotomolded housing.
•
Clean the area with a standard house-
hold cleaner.
•
Once dry, apply a durable label using
heavy-duty adhesive.
WARNING
Always disconnect the TurboDryer from its power
source before performing any maintenance or
cleaning.
):
ANTIMICROBIAL PROTECTION
A L
DHESIVE ABEL
:
: