Delta Innovex 276032AR Manual Del Usuario página 3

1
D e D e
p t h p t h
d t h d t h
W i W i
Verify that framing dimensions will accommodate product.
Consult specifications on pages 31-32 for your specific unit
to ensure site requirements are met - if you do not have
specifications for your unit, go to www.deltafaucet.com.
Clean debris from area and check for square and level of
framing (including floor).
CAUTION: Back stud wall and floor must be square for
proper installation.
3
Slide the base into the opening in the framing.
2
CAUTION: Top tub shower wall will not install
properly if back stud wall is not square to the floor.
4
Insert cardboard or other material into the sump and
across the front edge to protect surface. DO NOT remove
until all work has ceased in room.
4
5
Check level left to right and front to back.
CAUTION: Bathtub floor and dam has a slope and
should not be used for leveling.
7
Pull unit out of framing and install drain, waste, and
overflow assembly (not included). Follow manufacturer's
assembly instructions.
6
Mark unit position on all sides of framing after unit is leveled.
NOTE: These marks are used to verify bathtub location after
drain, waste, and overflow assembly are installed in Step 8.
NOTE: If not level, correct by shimming under base support.
CAUTION: DO NOT shim under the apron.
8
Ensure that the waste pipe is properly located to align with
the drain, waste and overflow assembly (not included).
Consult specifications on pages 31-32 for your specific unit
to ensure site requirements are met - if you do not have
specifications for your unit, go to www.deltafaucet.com
5