Yakima HullRaiser Manual De Instrucciones página 3

inserT bolTs inTo large holes in base
Make sure bolts are fully seated in base.
aTTaCh hex keys
load The boaT, Tie iT down
seCure sTraps
• Press open buckle.
• Insert end of strap.
1033428C-3/15
tIGHten
coMPLeteLY.
• Loop strap through
HullRaiser.
• Bring straps up and
over until they hang
in front of the boat.
MightyMounts must use kit #8860007
available from your YaKIMa dealer.
adjusT pads
foam pads can be
moved, or offset
to support boat at
contact points.
note: some lacquer hull
finishes may stick to pads.
Protect with soft cloth.
to tighten
straps, hold
and pull.
• Use longer
hex bolts with
hex wrench
from kit.
• TIGHTEN
COMPLETELY.
• Continue at
step 7.
• Slide buckle up
until it hangs at top
edge of boat.
• Thread end of strap
around tower or
crossbar.