Installing The Microphone; Adjusting The Microphone Angle - Pioneer FH-S725BT Guia De Inicio Rapido

Installing the microphone

The microphone should be placed directly
in front of the driver at a suitable distance
to pick up their voice clearly.
CAUTION
It is extremely dangerous to allow the
microphone lead to become wound
around the steering column or shift lever.
Be sure to install the microphone in such a
way that it will not obstruct driving. It is
recommended to use the clamps (sold
separately) to arrange the lead.
NOTE
Depending on the vehicle model, the
microphone cable length may be too short
when you mount the microphone on the
sun visor. In such cases, install the
microphone on the steering column.
To install on the sun visor
1
Fit the microphone lead into the
groove.
Microphone lead
Groove
2
Install the microphone clip on the sun
visor.
Lowering the sun visor reduces the
voice recognition rate.
10
En
Microphone clip
Clamps
Use separately sold clamps to
secure the lead where
necessary inside the vehicle.
To install on the steering
column
1
Detach the microphone base from the
microphone clip by sliding the
microphone base while pressing the
tab.
Tab
Microphone base
2
Install the microphone on the rear side
of the steering column.
Double-sided tape
Clamps
Use separately sold clamps to
secure the lead where
necessary inside the vehicle.
NOTE
Install the microphone on the steering
column, keeping it away from the steering
wheel.
Adjusting the microphone
angle
The microphone angle can be adjusted.