Broan 52WH344P Instrucciones De Instalación

MODEL: 52WH344P, 52WH344PF,
52WH344DP, 52WH346DP,
52WH344DPF, 52WH346DPF
RECESSED MOUNTED, STEEL BATH
CABINETS
INSTALLATION of CABINET
1. Carefully remove all packing material. Place hardware
packages, shelves and door aside until needed. Hard-
ware and shelves are located in the fillers identified
by "Hardware enclosed" tape.
2. Determine desired location of cabinet on wall. Mark
wall to show wall opening size (see dimension chart).
Generally, the recommended height to the center of
the cabinet is 64" from the floor. (Fig. 1)
3. CAUTION: Wall studs, plumbing or electrical lines that
interfere must be removed or relocated. Cut wall open-
ing, being careful not to damage the surrounding wall
surface. Insert framing to support all plaster board
edges.
Fig. 1
Fig. 3
Wall
Opening
For help, call us
toll free!
1-800-637-1453
Fig. 2
Insert screw
through clear
plastic base
Fig. 4
Cabinet
Body
INSTALLATION INSTRUCTIONS
MODEL NO.
52WH344P
52WH344PF
52WH344DP
52WH346DP
52WH344DPF
52WH346DPF
4. Prepare the mounting screws by placing the screws
into the clear plastic bases. (Fig. 2)
5. Note: For ease of installation, an additional person is
recommended.Insert cabinet into wall opening. (Fig.
3) Ensure the cabinet is plumb and level. If necessary
use a carpenter's level and shim corners of cabinet.
Secure to wall studs through the four (4) mounting
holes inside cabinet, using the screws that have been
placed into the plastic bases. (Fig. 4) Do not over
tighten the mounting screws as the body side wall may
bend and prevent proper shelf installation. Only tighten
screws until they are flush with the body.
6. Snap the screw covers over the screw bases. (Fig.5)
Mounting
Screws
WALL OPENING OVERALL SIZE
W H D W
1
14 / 34 4 15
4
14 1 / 34 4 15
4
1
14 / 34 4 15
4
14 1 / 34 6 15
4
14 1 / 34 4 15
4
1
14 / 34 6 15
4
Fig. 5
Snap on Cover
Screw
Base
Mounting
screw into
mounting
hole
H D
35 5
35 5
35 5
35 7
35 5
35 7
Cover