Broan 52WH244PA Instrucciones De Instalación

MODEL: 52WH244PA, 52WH244PT
RECESSED MOUNTED,
STEEL MEDICINE CABINETS
INSTALLATION of CABINET
1. Carefully remove all packing material. Place hardware
packages, shelves and door aside until needed. Hardware
and shelves are located in the fillers identified by
"Hardware enclosed" tape.
2. Determine desired location of cabinet on wall. Mark wall to
show wall opening size (see dimension chart). Generally,
the recommended height to the center of the cabinet is 64"
from the floor. (Fig. 1)
3. CAUTION: Wall studs, plumbing or electrical lines that
interfere must be removed or relocated. Cut wall opening,
being careful not to damage the surrounding wall surface.
Insert framing to support all plaster board edges.
4. Prepare the mounting screws by placing the screws into
the clear plastic bases. (Fig. 2)
5. Note: For ease of installation, an additional person is
recommended. Insert cabinet into wall opening. (Fig. 3)
Ensure the cabinet is plumb and level. If necessary use a
carpenter's level and shim corners of cabinet. Secure to
wall studs through the four (4) mounting holes inside
cabinet, using the screws that have been placed into the
plastic bases. (Fig. 4) Do not over tighten the mounting
screws as the body wall may bend and prevent proper shelf
installation. Only tighten screws until they are flush with
the body.
6. Snap the screw covers over the screw bases. (Fig. 5)
INSTALLATION of DOORS
1. Remove hinges and screws from hardware bag. Mount
hinge unit on door as shown in Fig. 6 securing with screws
provided.
2. Install the door by inserting door side of the hinge into the
bracket on the body as shown in Fig. 7.
3. Check door for proper alignment. If the door needs to be
adjusted please refer to the adjustment procedures in Fig.
8. Door edges should be aligned with the edges of
the body and should fit evenly to the face of the body.
4. Snap on hinge cover plate. (Fig. 9)
Fig. 7
Press down
on hinge until
it clips in place
F o r h e l p , c a l l u s t o l l F o r h e l p , c a l l u s t o l l F o r h e l p , c a l l u s t o l l F o r h e l p , c a l l u s t o l l F o r h e l p , c a l l u s t o l l
Fig. 8
Hook bottom of
hinge into place
on the bracket
This screw
for depth
adjustment
INSTALLATION INSTRUCTIONS
f r e e ! f r e e ! f r e e !
f r e e ! f r e e !
1-800-637-1453 1-800-637-1453 1-800-637-1453
1-800-637-1453 1-800-637-1453
Fig. 1
Approx.
64" to
Floor
Fig. 3
Cabinet
Body
Fig. 5
Snap on Cover
Screw
This screw for
up and down
adjustment
This screw
for left and right
adjustment
MODEL WALL OPENING
NO. W H
52WH244PA 14 1 / 24
4
52WH244PT 14 1 / 24
4
Fig. 2
H
D
W
Wall
Opening
Mounting
Screws
Fig. 6
Hinge Mounted
to Door
Cover
Base
Fig. 9
Hinge Cover
OVERALL SIZE
D W H D
4 15 31 1 / 5
4
4 15 31 1 / 5
4
Insert screw
through clear
plastic base
Fig. 4
Mounting
screw into
mounting
hole