Broan 52WH244P Instrucciones De Instalación

MODEL: 52WH244P, 52WH244PF,
52WH244DP, 52WH246DP,
52WH244DPF, 52WH246DPF
RECESSED MOUNTED, STEEL
MEDICINE CABINETS
INSTALLATION of CABINET
1. Carefully remove all packing material. Place
hardware packages, shelves and door aside until
needed. Hardware and shelves are located in the
fillers identified by "Hardware enclosed" tape.
2. Determine desired location of cabinet on wall.
Mark wall to show wall opening size (see
dimension chart). Generally, the recommended
height to the center of the cabinet is 64" from the
floor. (Fig. 1)
3. CAUTION: Wall studs, plumbing or electrical lines
that interfere must be removed or relocated. Cut
wall opening, being careful not to damage the
surrounding wall surface. Insert framing to
support all plaster board edges.
Fig. 1
Fig. 3
Wall
Opening
For help, call us
toll free!
1-800-637-1453
Fig. 2
Insert screw
through clear
plastic base
Cabinet
Body
INSTALLATION INSTRUCTIONS
MODEL
NO.
52WH244P
52WH244PF
52WH244DP
52WH246DP
52WH244DPF
52WH246DPF
4. Prepare the mounting screws by placing the
screws into the clear plastic bases. (Fig. 2)
5. Note: For ease of installation, an additional person is
recommended.Insert cabinet into wall opening. (Fig.
3) Ensure the cabinet is plumb and level. If
necessary use a carpenter's level and shim corners of
cabinet. Secure to wall studs through the four (4)
mounting holes inside cabinet, using the screws that
have been placed into the plastic bases. (Fig. 4) Do
not over tighten the mounting screws as the body
side wall may bend and prevent proper shelf
installation. Only tighten screws until they are
flush with the body.
6. Snap the screw covers over the screw bases.
(Fig.5)
Fig. 4
Mounting
Screws
WALL OPENING OVERALL SIZE
W H D W
14 1 / 24 4 15 25
4
14 1 / 24 4 15 25
4
14 1 / 24 4 15 25
4
1
14 / 24 6 15 25
4
14 1 / 24 4 15 25
4
14 1 / 24 6 15 25
4
Fig. 5
Snap on Cover
Screw
Base
Mounting
screw into
mounting
hole
H D
5
5
5
7
5
7
Cover