Maintenance - Dremel 3D40 FLEX Traducción De Las Instrucciones Originales

MAINTENANCE

UNCLOGGING THE EXTRUDER
Use the unclogging tool to clean the extruder and
unclog built up filament.
1. Wait for extruder to heat up insert the unclog tool
into the extruder intake (top).
2. Clogged debris will be pushed down and will
extrude from the extruder tip.
UPDATING FIRMWARE VIA NETWORK
If your 3D40 FLEX is registered and added to your
Dremel3D profile, you can update its firmware directly
from the touchscreen. To update firmware:
1. Tap "Tools", "Settings", "Check for Updates".
FIG. 10
2. Your 3D40 FLEX will check to see if it has the
latest firmware installed and ask if you would like to
update if one is needed.
3. Choose accept to download and install the latest
firmware.
4. When the 3D40 FLEX starts up and returns to the
Home Screen, firmware update is complete.
27