General Information; Assistance And Repairs - Alpine ST 5148 Li Uso Y Mantenimiento

LED (5a)
RED (Flashing) Charge anomaly and possible
faulty battery; in this case remove
the battery and replace it within 2
hours: if the LED indicates charging
status, this means that the battery is
in good condition and the charging
can proceed as normal. Otherwise:
- disconnect the battery charger,
wait a few minutes, and reconnect
it to the mains again;
- remove the battery from the
charger, wait a few minutes, and
replace it again.
If, after all these attempts, the LED
(5b) does not indicate the charge
status and continues to flash, this
means that the battery is faulty and
needs replacing.
8. MAINTENANCE

8.1 GENERAL INFORMATION

IMPORTANT The safety regulations to
follow during machine use are described in
par. 2.4. Strictly comply with these instructions
to avoid serious risks or hazards.
All service and all maintenance checks
must be carried out on a stationary machine
with the motor switched off. Before any
maintenance operation, switch off the motor
and remove the key from the compartment.
Wear adequate clothing, gloves
and goggles before carrying
out any maintenance.
• The frequency and types of maintenance
are summarised in the "Maintenance
Table". The table will help you maintain
your machine's safety and performance.
It summarises the main interventions to
be made and the frequency applicable
to each of them. Carry out the relevant
intervention according to the first deadline.
• The use of non-genuine spare parts and
accessories could adversely affect machine
operation and safety. The manufacturer shall
decline all liability in the event of injuries
or damages caused by such parts.
• Genuine spare parts are supplied by
authorized assistance workshops and dealers.
IMPORTANT All the maintenance and
adjustment operations not described
Meaning
EN - 10
herein must be carried out by your dealer
or Authorised Service Centre.
8.2 CLEANING
Carry out cleaning operations with the
machine switched off Do not try to remove
snow from the discharge without firstly:
• Releasing the auger control.
• Removing the ignition key
• Removing the battery
Always clean the machine after use.
To clean the machine adhere to the
instructions provided below:
• Stop the motor
• Remove the battery from its compartment.
• Cool the snow thrower.
• Clean the snow thrower internally
and externally with an adequate
brush and/or compressed air.
Never wash the snow thrower with
water, otherwise the electric device will be
damaged causing the risk of electrocution.
9. STORAGE
If you intend to put your machine
away for more than 30 days:
5. Clean the snow thrower thoroughly.
6. Check for any damage. If necessary,
see to the necessary repairs.
7. If the paintwork is damaged,
touch it up to prevent rust.
8. Protect any exposed metal surfaces from rust.

10. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorized Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorized
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only authorized service workshops can carry
out guaranteed repairs and maintenance.