Service Parts - Broan QTR Serie Guia De Inicio Rapido

CONNECt WIrING
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.

SErVICE PArtS

Key No. Part No.
1 97016466 Housing
2 97016449 Duct Connector-4"
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97016932 Wire Panel/Harness Assembly
6 99020284 Blower Wheel
7 99080560 motor (QTR050)
99080568 motor (QTR080)
99080582 motor (QTR110)
99080580 motor (QTRE080, QTRE110)
8 99100491 Isolator (4 req'd)
9 97016468 Motor Plate
10 99250959 washer #8 (4 req'd)
11 99260558 Nut, Hex lock #8-32 (4 req'd)
* 97016587 Blower Assembly (QTR050)
* 97016621 Blower Assembly (QTR080)
* 97016739 Blower Assembly (QTR110)
* 97016738 Blower Assembly (QTRE080, QTRE110)
12 97016497 Grille Assembly
13 99140199 Grille Spring (2 req'd)
14 99111293 Spacer (2 supplied)
15 QTHB1 Hanger Bars
16 99420665 Thumbscrew, #8-18 x .375
Order service parts by "Part No." - not by "Key No."
* Not shown assembled.
SErVICE NOtE To remove Blower Assembly: Unplug motor (7). Remove
thumbscrew (16) from motor plate (9) flange. Find the single tAB on the motor plate (located
next to the receptacle). Push up near motor plate tab while pushing out on side of housing.
or insert a straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver.
Description
(includes key nos. 6 thru 11)
(includes key no. 13)
qtrE080 • qtr110 • qtrE110
INStALL GrILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots on
each side of hous-
ing.
7. Push grille
against ceil-
ing.
Replacement parts
can be ordered on our
website. Please visit us
at www.broan.com
TAB
MODELS qtr050 • qtr080
Page 
99043843D