Operation - Glacier bay F51AC074CP Guía De Instalación Y Cuidado

Installation (continued)
8
Making the water supply connections
Use 1/2 in. I.P.S. faucet connections (1), or a 3/8 in.
O.D. ball-nose riser (2) with supply line coupling
nuts (3) (not included).
Use a wrench to tighten the connections. Do not over
tighten or torque the copper supply line.

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove
the aerator to the flush the water lines. Do not lose the
gasket in the aerator.
Ensuring the handles are in the off position, turn on
the water supply and check for leaks. If you discover
any leaks, check your connections to ensure they are
installed properly.
Use the aerator wrench to remove the aerator (B) and
housing (if applicable). Turn on the hot and cold handles
to allow the water to run for at least one minute. This
flushes away any debris that could cause damage to
internal parts.
Turn off the water and reinstall the aerator and housing
(if applicable).
1
A
B
7
2
3
HOMEDEPOT.COM/GLACIERBAY