Operation - Glacier bay HD67596W-7001 Guía De Uso Y Mantenimiento

Installation (continued)
6
Making the water supply
connections
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
other and damaging. Clean the the screen lter in the
connector (F) regularly.
□
Thread the connector (F) onto the outlet of the
water supply valve (1), then thread the nut (2)
on the supply line onto the connector (F) and
tighten with a wrench. Do not overtighten.

Operation

1
Flushing and checking for leaks
□
Ensure the faucet (A) handle is in the off
position, and turn on the water supply to check
for leaks. If you discover any leaks, check your
connections to ensure they are installed properly.
□
Turn on the hot and cold water handle to allow
the water to run for at least one minute. This
ushes away any debris that could cause
damage to internal parts.
□
Turn off the water.
2
F
1
H
6
Please contact 1-855-HD-GLACIER for further assistance.
2
F
1
C
A
HOMEDEPOT.COM