CVTECH Freedom Electra Manual De Instrucciones página 20

Follow the same method for adjusting the number shown in the display until the second and the third
numbers displayed are the pre-set code numbers. Then press the " " button to confirm.
NB.: If the user presses the "RESET" button during the process, he will return to the start of the process,
and any values that have been entered will be cancelled.
The PIN code having been confirmed a "P" is shown in the display. Press the " " button to confirm.
In the case that the PIN code is not the correct one, you can exit from the procedure and try again.
If the code you enter is the same as the pre-set PIN code, you will be allowed to proceed to "Re-
establishment of the PIN code" and then to the "Re-establishment of the parameters".
Press the " " button to enter "Re-establish parameters" or press the "+" and " " buttons simultaneously
to enter "Re-establishment of the PIN code".
Re-establishment of the PIN code.
Important: Before changing the PIN code please memorize the new one. Should you forget the new code
you will not be able to access the programming mode.
1. When you have finished the introduction of the pre-set PIN code, press the "+"button and the " "
button at the same time to enter the procedure for re-setting the PIN code. The indicators "PROG" and
"PIN" will be illuminated for one second.
2. An "X" appears in the number display, this will be the first number of your personalized PIN code.
Press the "+"button and the "-"button to adjust the number showed in the display until you see the number
you want. (If you don't wish to re-set the code, just press the " " button to proceed).
3. Use the same method to adjust the second and the third number of the PIN code.
4. The entry of the new values is now complete but the new PIN code is not yet registered in the system
memory. Now you should see a "P" in the number display. To register your new PIN number press the
" " button within 30 seconds.
If you don't press the " " button within 30 seconds, your new PIN code won't be registered and the
central vacuum unit will revert to the factory settings.
NB: if during the course of the operation you press the "RESET" button, the procedure will be cancelled
and the pre-set values won't be modified.
Modification of the running settings.
You can vary the maintenance times according to your frequency of use, but bear in mind that the
central vacuum comes from the factory already configured for normal usage.
HEPA (Filter) Cleaning Time: a set of 2 decimal numbers, in the range 00 to 99, measuring "HOURS" (H).
Container Full Time: a set of 2 decimal numbers, in the range 00 to 99, measuring, "HOURS" (H).
Motor Maintenance Time: a set of 3 decimal numbers, in the range 000 to 999, the unit of measurement
being "HOURS" (H).
USER GUIDE 18