Maintaining Your Central Vacuum Unit - CVTECH Freedom Electra Manual De Instrucciones

Your central vacuum arrives pre-programmed with the following values:
Filter = 30 H
Full Container = 15 H
Motor Maintenance = 400 H
If you want to modify these parameters, follow this procedure:
1. Introduce your PIN code according to the procedure described above, then a "P" will show in the
display. Press the " "button within 30 seconds to enter the "re-setting and confirmation of the parameters"
mode.
2. The "PROG" and "FILTER" indicators will light up and an "X" appears in the display, This represents
the first digit of the Filter Time. Press the "+" button or the "-" button in the range 00 to 99, to alter the
number displayed until the number you want appears. Then press the " " button to confirm the number
you have selected. (If you don't want to change the value, just press the " " button in order to proceed.)
Follow the same procedure to set the second digit of the Filter Time.
3. The "PROG" and " CONTAINER FULL" indicators will then light up and an "X" appears in the
display, it represents the first digit of the CONTAINER FULL" Time. Press the "+"button or the "-"button
to alter the number displayed until it is the number you require.
Then press the " " button to confirm the number that you have selected. (If you don't want to modify
this parameter, press the " " button to proceed).
4. The "PROG" and "MOTOR MAINTENANCE" indicators will then light up . An "X" appears in the
number display to represent the first digit of the "MOTOR MAINTENANCE" Time that you want to set.
Press the "+"button and the "-"button to alter the number that is shown in the display until the required
digit appears. Then press the " " button to confirm the number which you have set. (If you don't want to
modify this parameter, just press the " " button to proceed). Follow the same procedure to set the third
digit of the "MOTOR MAINTENANCE" Time.
To register the new time values press the " " button within 30 seconds in order for the new time values
to be registered. These are now set. If you don't press the button to confirm within 30 seconds, the new
time values won't be recorded and the time values will revert to the factory settings.
NB If during the programming process you don't press the button to confirm within 30 seconds , the
process will be cancelled and the numbers that you have introduced won't be registered.
If during the process the "RESET" button is pressed, then the process will be cancelled and the system
reverts to the pre-set parameters.
If at any time during the modification of the three time parameters you press the " ", button no new
values will be recorded in the memory.

7.2. MAINTAINING YOUR CENTRAL VACUUM UNIT.

In the event that the display indicates the need to clean or change the filter you need to press the re-set
button and then restart the central vacuum unit.
Should the "FILTER" and "FULL DUST CONTAINER FULL" indicators light up simultaneously on
the control panel you need to press the reset button and then switch off and switch back on the central
vacuum unit twice.
USER GUIDE 19