Assembly/Preparation - Imetec SM2 Instrucciones Para El Uso

DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (fig. A)
1. removable pillow
2. back rotating massaging heads
3. securing straps
4. connectors
5. mains power supply with connector
6. control
7. control sleeve pocket

ASSEMBLY/PREPARATION

• Unpack the product and remove the stops used for transport.
• Check that it is integral and undamaged.
ATTENTION!
The massager will be irreparably damaged and it will no longer be usable unless the
transport safety screw is removed before using the product. This case is not covered by
warranty. Once removed, the screw must no longer be re-inserted.
• The massager is supplied with Velcro securing straps making it possible to adapt it to the majority of chairs
available on the market. Pass the two straps (3) behind the chair back and secure them to each other
using the Velcro. If you prefer, simply rest the massager on your chair or armchair. Do not use it on wooden
surfaces as they may be damaged.
ATTENTION!
The massager is unsuitable for use in a car.
• Connect the transformer to the massager via the specific connectors (4).
• Connect the product to the domestic mains.
USE
• Press the POWER button once to turn the massager on.
Three types of alternative massage can be selected:
• Circular
• Swing
• Linear
CIRCULAR: circular massage.
Depending on the part to be massaged, press keys:
• UPPER: massage on upper back. Choose this type by pressing the corresponding button.
• FULL: full back massage. Choose this type by pressing the corresponding button.
• LOWER: massage on lower back. Choose this type by pressing the corresponding button.
Upon commissioning, release the transport safety device of the massaging
mechanism. Loosen the screw on the rear of the chair back using the appropriate
tool.
EN
51