Maintenance And Storage; Problems And Solutions - Imetec SM2 Instrucciones Para El Uso

MAINTENANCE AND STORAGE
Always disconnect the appliance from the mains supply before cleaning or maintenance and when the
appliance is not in use.
The massager can be cleaned with a soft slightly damp cloth. It is also possible to use a light detergent.
Keep the massaging appliance out of children's reach in a cool dry place.
PROBLEMS AND SOLUTIONS
These appliances are built with the highest standards. No parts can be repaired by the user. If the appliance
does not work, follow the solutions.
Problem
The appliance makes noise
during use.
Noise during the massage grows.
Irregular right or left movements
of massager mechanism.
It does not move or else it stops
during the massage.
If other situations not included above should occur, pull out the plug, wait a few minutes, put the plug back
in and turn the appliance back on.
Should the appliance keep on having problems, contact the authorised assistance centre.
Possible cause
This is evitable, but the
appliance is not faulty.
Has it been used for too
long without interruption?
It is structural.
The timer switched off the
appliance.
Has the rear fastening
screw been removed?
Is the plug still in the
socket?
Is the switch on?
Has the appliance turned
off for excessive weight?
Solution
It does not affect the duration of the
appliance.
Turn the appliance off and have it rest
for over an hour.
It is not an alteration.
Press the start button again.
Remove the rear fastening screw.
Insert the plug in the socket.
Turn the appliance on.
Remove the weight and wait a few
minutes. The appliance will turn back
on.
EN
53