Product Dimensions; Location Requirements - KitchenAid KDDO27TRX Manual De Instalación

Drawer Front #8 x ¹⁄₂" Pan-head Screw Locations
A
A. Pre-drilled screw locations
Hardware (optional)
Customer supplied handles may be installed at this time. Be sure
when installing custom hardware that the mounting screws are
flush with the back of the panels.

Product Dimensions

Styles 1 and 2: Standard and Overlay
Height dimensions are shown with the leveling legs extended
to the minimum height of ¹⁄₄" (6.35 mm) below the refrigerator
drawers.
When leveling legs are fully extended to 1" (25 mm) below the
refrigerator drawers, add ³⁄₄" (19.05 mm) to the height
dimensions.
The power cord is 60" (152.4 cm) long.
23.5"
(59.6 cm)
A
A
26.7"
(67.9 cm)
34.0"
(86.3 cm)
Drawer Opening Dimensions
Dimensions vary based on model, as shown.
A
B
A
A. Style 1: Standard
B. Style 2: Overlay—Measurement does
not include
panel or optional hardware

Location Requirements

Keep flammable materials and vapors, such as
gasoline, away from refrigerator drawers.
Failure to do so can result in death, explosion, or fire.
NOTES:
For the refrigerator drawers to be flush with the front of the
base cabinets remove any baseboards or moldings from the
rear of the opening. See "Product Dimensions" and later in
this section "Opening Dimensions (both styles)."
It is recommended that you do not install the refrigerator
drawers near an oven, radiator, or other heat source.
Do not install in a location where the temperature will fall
below 55°F (13°C).
Opening Dimensions (both styles)
Height dimensions are shown with the leveling legs extended
to the minimum height of ¹⁄₄" (6.35 mm) below the refrigerator
drawers.
NOTE: When leveling legs are fully extended to 1" (25 mm)
below the refrigerator drawers, add ³⁄₄" (19.05 mm) to the
height dimensions. See "Product Dimensions."
20.9"
(53.1 cm)
18.2"
(46.2 cm)
³⁄₄
" (19.05 mm) overlay
WARNING
Explosion Hazard
5