Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Built-in opening
requirements &
dimensions
All dimensions ±1/8" (3 mm)
A solid soffit or two, 2" x 4" x 32"
(5 cm x 10 cm x 81 cm) wood boards
to cover the width of the compressor
cover are required above the
refrigerator to prevent tipping
during use.
If solid soffit is more than 1 inch
(2.5 cm) above refrigerator, two
2"x 4" x 32" (5 cm x 10 cm x 81 cm)
wood boards must be installed on
the wall 1/4 inch (6 mm) above the
refrigerator cover. The bottom
surface of the boards should be
84 inches (213 cm) from floor. Boards
must be long enough to fully cover
width of compressor cover.
The built-in refrigerator can be
installed:
• recessed in the cabinet opening.
• at the end of cabinets using a side
panel to enclose the side of the
refrigerator.
Select one method and use dimensions
given. Dimensions shown provide
0" (0 cm) clearance.
Mark stud
locations on
rear wall
80" - 90"
(203-229 cm)
above floor.
Height
Install side panel (optional)
support board on rear wall
if opening depth is
25" (63.5 cm) or more.
Water line must
provide 15-100 psi
(103-690 kPa) water
pressure. Rough in
water line before
installing
refrigerator.
2" (5 cm)
Depth
Floor: Must support refrigerator,
contents, and door panels.
Opening dimensions
Width min.
35-1/2" (90 cm)
Height min.
83-1/4" (211.5 cm)
Height max.
84-3/4" (215 cm)
Depth min.
23-1/2" (60 cm)
7"
(18 cm)
Grounded electrical
outlet location
Grounded electrical
outlet is required.
(196 cm)
Width
Water line
location can be
through floor
or wall.
7"
(18 cm)
5-1/2"
(14 cm)
3"
(7.6 cm)
10"
(25 cm)
8"
(20 cm)
(15 cm)
77"
1/2" (12 mm) hole for
plumbing can be
located anywhere
within shaded area.
6"
Page 3
Publicidad
Tabla de contenido
